Frequently Asked Question

PROGRAMMING PROCEDURE

1) Push the RESET button at the rear of the control box.

2) Push the SET button at the rear of the control box. SET mode LED will blink.

3) Enter 3333 and push “L” key. (This resets memory of default values.)

4) Enter specified pulse count and push the “L” key.

5) Enter the first slot or frame number and push GO key.

6) Enter last slot or frame number and push the “R” key.

7) Enter the slot or frame number at the picking station, than press the STOP key.

8) Push SET button. The SET MODE LED will stop blinking. PROGRAMMING IS COMPLETE.